The use of blister forming machine

Blister forming machine is also known as extruder or thermoforming machine, has the work process is simple, powerful, widely used, etc, is the use of more plastic machinery equipment. Plastic products is widely used nowadays, then under the growing market demand, the use of sheet forming machine note also pay particular attention to. First, in sheet forming machine, pay attention to clean up its first before starting the work surface and the surrounding environment, and forming die is wiped clean. Carefully check sheet molding machine power button, control system, and the heating system components, such as confirmation after its normal add lubricant as required. Second, the sheet forming machine, before starting the note about four fifty-minute heating. Will increase temperature to hand pulling motor v-belts, until freely, according to the normal work again spin to pull straight eight to ten times. After ten minutes or so and then continue to heat up to boot, but still want to continue to heating, because the normal production need to continue to supply heat, operators according to different properties of the plastic to adjust temperature. Moreover, the normal work of the sheet forming machine, pay attention to the engine temperature will remain stable, high and low. Especially near the vent hole, until the nose position to maintain a temperature of 200 ℃ or so ( Refers to the c, b) 。 Not only that, sheet molding machine into material should pay attention to whether even, have to foot, because the machine into the feeding speed and feed speed to cooperate proper, or it will affect the quality of the grains and yield. In addition when stop, sheet forming machine of the host to completely cut off the power supply, and the nose plug ( With wrench part) Must be picked. For sheet forming machine after the next separately and preheating before use.