The characteristics of high speed vacuum vacuum forming machine and daily use pay attention to the problem1

1. USES vertical pull piece of design: pull uniformity and stability of fast, shorten the holding time, the environmental protection material more adaptability and lower power consumption, ensure the quality of product molding. 2. Independently grouped temperature control: the use of special dense plane far-infrared ceramic chip assembly, temperature uniformity, 50% higher than traditional machine save electricity. 3. Adopting the enclosed heating, electric heating furnace heating more even and reducing heat loss, and comes with a manual switch, vertical lift, control of electric furnace in the process of production, control product quality. Thick film or PP sheet can adopt double electric furnace heating up and down, Customer order) To speed up the heating time, improve production speed. 4. This machine is equipped with vibration membrane device, for complex product is not easy to deformation, demoulding easy. 5. Double row needle chain transmission, high-speed operation to ensure accurate and stable, with a width adjustable device, make the best use of mechanical energy of film and reduce waste. 6, the whole machine is equipped with water cooling device and high-speed cold water spray, speed up the molding and ensure the quality of molding, production speed is faster than the traditional one times. 7. Built-in set two vacuum, make difficult products are more likely to molding, improve product quality, reduce scrap rate. 8. The whole machine adopts imported equipment and international pneumatic components factory, quality is absolutely reliable, safe and durable. More information about high speed vacuum vacuum forming machine can direct access to the web site:.