After the 'scrap ban' plastic thermoforming machine material pp pattern of supply and demand change

Pvc plastic thermoforming machine webex, in 2017, domestic PP plastic thermoforming machine material new capacity of about 1. 26 million tons/year an app, compared to the capacity of 2. 4 million tons/year last year cut 47. 5%. Including shenhua ningxia coal coal project two lines is about 600000 tons/year, 2017 by the end of a line of 300000 tons/year, in January 2018, the second line drive. 2018 years later, still more domestic PP material new capacity, especially the new capacity is expected in 2019 4. 15 million tons/year, but because the new assembly delay is perhaps rate event, and early operation is not stable. Therefore, PP material production release large uncertainty, PP material supply and demand pattern face rebalancing. Before, during and after the 'forbidden' waste PP reworked material to the transition of the domestic and imported special is very obvious, the second half of 2017, imports will present situation of shrinking month by month, year accumulative total cut more than 200000 tons, and 2018 - In 2020, PP reworked material imports inheritance to shrink, and expand the scale, after three years of adjustment, is expected to begin in 2020, PP reworked material market stabilization picks up year by year, is expected to import around 200000 tons. Because of the 'waste' ban normalized and environmental requirements, the size of the PP raw material imports again in the future is difficult to restore to the front of the 'waste' ban levels, important squeezed by PP domestic renewable and material. 'Ban waste' when viewed from the outside is advantageous to the domestic market, but with the domestic environmental protection finishing normalized, domestic market is not optimistic. 2017 - Production market down trend manifested that year by year, 2020 countries, 2020 years after the 'forbidden' waste PP renewable the yield down to 2. 7 million tons. As the renewable market standardization, 2021 PP renewable production will be stabilising picks up to 3. 1 million tons, is still difficult to restore to the front of the 'waste' ban. Because PP material of reworked material to replace in the future is more USES, so it is irreversible, so PP material and reworked material market is facing reshuffle. From the PP material supply and demand trends, 2010 - In 2016, average growth in supply 8. About 05%, average growth in demand for 7. Less than 85% personnel test center of chengdu, demand growth supply growth, pressure of supply and demand rise. 2017 - In 2021, PP material supply growth in June. About 05%, average growth in demand for 6. Around 01%, the supply and demand growth is flat, the PP material pattern basic balance between supply and demand, but because of 'waste' ban after PP material, on growth of reworked material to replace certain extent, expanded the demand of the new material. Comprehensive analysis, the 'forbidden waste' does not have any effect on the PP material supply market, affect the important part of the PP material demand, especially for 2018 years after the influence will be strengthened. 2018 PP material capacity growth slowed, the market supply and demand pattern slightly tight, and the demand of the 'waste' ban release most of transfer to the PP material, the PP material market will play a certain support. In the long run, the PP material is USES for the reworked material to replace the important replacement, such as plastic woven, injection molding, and other fields, has the characteristics of irreversible, at the same time, domestic environmental policy in the future will support renewable plastic thermoforming machine, so the PP reworked material of PP material replacement will be weakened. Comprehensive analysis, predict the future of domestic PP raw material and then replace with the replacement market weakened gradually, the two will follow its own development path of the road.