Coating machine operation method for laboratory

Coating machine used for the laboratory preparation machine out of the box, there are three parts: 1, 2, scraper component 3, the power cord options: 1, 2, vacuum drying system, system 1 】 The machine of wooden cases and cartons carefully apart, it is forbidden to inverted break a machine on bearing smooth surface 2 】 Check all the exterior parts, ensure no damage deformation, loosening. 3 】 Scraper part number: 2 is separated from the whole place, check the blade, rotate around digital display table adjusting knob at the same time, observe whether the blade can move up and down, confirmed, open the switch display, transferred to the MM units, as the reset button. 1 】 boot debugging After the first two steps on 220 v power supply 2 】 Press the power button on the panel machine green light will light up, will hear a motor electrical pulse sound 3 】 Press start button gently, the thrust lever number: 3 will move to the right, then will turn back to stay in the starting point 4) Machine into standby, no-load commissioning first, lightly press the start key again, the thrust lever number: 3 the movement to the left at a certain speed, buffer stops after reach the finish line. 5 】 Press start button again, thrust rod will return to the origin from the end to stop, now a running process to finish 6 】 Shift: the switch gear storage number: 12 rotate to '2', then press the start key light, thrust rod will move to the left at a faster speed, buffer stops after reach the finish line. 7 】 Press start button again, thrust rod will return to the origin from the end to stop, at this point and a running process to finish 8 】 Rotating stall switch to '3' again, repeat the above action, to observe the running speed of the thrust lever, will be faster. 9 】 Load the debugging, buckle on the thrust lever scraper components, to confirm, fastened up scraper complete contact at the bottom of the glass platform 10 】 After 3 - Eight steps, observe whether move line is smooth, smooth.